Cover Image
close this bookManufacture of Ceilings - Course: Timberwork techniques. Trainees' handbook of lessons (Institut für Berufliche Entwicklung, 22 p.)
View the document(introduction...)
View the document1. Purpose of Ceilings
View the document2. The Wooden Beam Ceiling
View the document3. The Framing
View the document4. The Attic and Collar-beam Framing
View the document5. The Pitch Size
View the document6. Load on Wooden Beams
View the document7. The List of Timber
View the document8. The Wall Plate
View the document9. Flooring Sleepers
View the document10. Special Constructional Recommendations

4. The Attic and Collar-beam Framing

The attic framing is the top framing.

It supports the roof structure.

All partition walls and the centre wall are ending beneath the attic framing. Fire walls, however, extend until beneath the roofing.

Because the attic framing supports the roof structure, the wooden beams of this framing may have different widths. They all should, however, have the same height!

Why should all wooden beams of the attic framing have the same height?

____________________________________________

For equidistant distribution of the beams it is important that the joining beams should not exceed a distance of 4000 mm.

What purpose do the joining beams serve in the attic framing?

____________________________________________

It is recommended to fix the location of the joining beams and then to calculate the pitch size for the intermediate beams between them.


Figure 10

Pitch size between joining beams

1 joining beam, 2 intermediate beam, 3 wall plate, b1, b2 width of wooden beams, T pitch size, Lr arithmetical length for pitch size calculation

The pitch size can be calculated to formula (1) in section 5 hereof. In addition to the floor mark and a number, the joining beams also have a marking-out mark.


Figure 11

Wooden beams marked with floor mark, jointing mark, number and marking-out marks

1 intermediate beam, 2 joining beam, 3 wall plate, 4 inner or centre wall, 5 outer wall
a marking-out mark for straight tenons, b marking-out mark for angular tenons, c void mark

Why do the wooden beams of a framing have a number and a floor mark?

____________________________________________

What are marking-out marks?

____________________________________________

The collar-beam framing is no typical wooden beam framing. It is mainly applied in a rafter roof. The purpose of the collar beams is to stiffen the rafter pair of a rafter roof.

But collar beams may also be built into a purlin roof when the roof room is very high and shall be used effectively.