Cover Image
close this bookOperations on Smooth Miller and Thicknessing Miller - Course: Mechanical woodworking techniques. Trainees' handbook of lessons (Institut für Berufliche Entwicklung, 10 p.)
View the document(introduction...)
View the document1. Purpose of Milling at the Smooth Miller
View the document2. Construction of the Smooth Miller
View the document3. Setting of the Smooth Miller
View the document4. Milling of the Workpieces
View the document5. Purpose of Milling on the Thicknessing Miller
View the document6. Construction of the Thicknessing Miller
View the document7. Setting of the Thicknessing Miller
View the document8. Milling of the Workpieces
View the document9. Tasks

9. Tasks

What is the purpose of milling on the smooth miller?
_____________________________________________
_____________________________________________
_____________________________________________

Which setting is done at the feeding table of the smooth miller?
_____________________________________________
_____________________________________________
_____________________________________________

What for is the stop bar of the smooth miller?
_____________________________________________
_____________________________________________
_____________________________________________

What is the feeding device used for?
_____________________________________________
_____________________________________________
_____________________________________________

Why is to make use of ear protectors?
_____________________________________________
_____________________________________________
_____________________________________________

Why is the left cover of the cutter spindle adjustable?
_____________________________________________
_____________________________________________
_____________________________________________

For what purpose is milling on the thicknessing miller?
_____________________________________________
_____________________________________________
_____________________________________________

What is the use of the sliding rolls inserted in the machine table?
_____________________________________________
_____________________________________________
_____________________________________________

What is the use of the both pressure beams?
_____________________________________________
_____________________________________________
_____________________________________________

What is the rebound protection for?
_____________________________________________
_____________________________________________
_____________________________________________

Milling a workpiece with lower rate of feed, milling a workpiece with high rate of feed.

What does become appearent when comparing both workpieces?
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________

How is the dimensional accuracy to be checked?
_____________________________________________
_____________________________________________
_____________________________________________