Cover Image
close this bookOperations on Smooth Miller and Thicknessing Miller - Course: Mechanical woodworking techniques. Trainees' handbook of lessons (Institut für Berufliche Entwicklung, 10 p.)
View the document(introduction...)
View the document1. Purpose of Milling at the Smooth Miller
View the document2. Construction of the Smooth Miller
View the document3. Setting of the Smooth Miller
View the document4. Milling of the Workpieces
View the document5. Purpose of Milling on the Thicknessing Miller
View the document6. Construction of the Thicknessing Miller
View the document7. Setting of the Thicknessing Miller
View the document8. Milling of the Workpieces
View the document9. Tasks

8. Milling of the Workpieces

After setting the milling thickness switch on the machine and slip in the workpieces by hand until they are taken by the feed roller. The feed device does the transport during the milling operation.

The rate of feed is adjustable and is between 5 - 25 m per minute. The lower the rate of feed is chosen the better the quality of the surface will be.