|Amplifier Teaching Aid (DED Philippinen, 86 p.)|
|Lesson 10 - Large Signal Amplifier|
Title: Large Signal Amplifier
- Understand the importance of amplifier efficiency
- Know the most common classes of power amplifier and their basic characteristics
The early stages of amplifier systems are dealing with small signals. These stages are designed to give good voltage gain. Small signal transistors have a power rating of less than half a watt and power transistors have a power rating of more than half a watt.
The later stages of an amplifier system have much larger collector currents, because the load impedances are much smaller (i.e.: Loudspeaker 1W, 4W, 8W, 16W).
Efficiency is most important when large amounts of signal power are required:
This refers to how the amplifying device is biased. Amplifier can be biased for class A, B or AB operation.
The amplifiers we have discussed have been class A amplifiers. Class A amplifier operate in the center of the load line. This gives the best possible output swing without clipping.
Efficiency: low, maximum 50%
Even when no signal is applied, a high current is flowing (100 mA) and there is a power dissipation in the load.
Applications: Few audio amplifier (high quality)
Fig. 10-1: Class A amplifier
The class B amplifier is biased at cutoff. No current will flow until an input signal provides the bias to turn on the amplifier.
Fig. 10-2: Q point of a class B amplifier
Only one half of the input signal is amplified. Two transistors can be operate in class B together in one circuit, one transistor for the positive portion of the signal and one transistor for the negative portion of the signal (Push Pull):
Fig. 10-3: Push Pull amplifier
Fig. 10-4: Signal swing of a. push pull amplifier, Class B operation
Problem: Crossover distortion, the emitter diode takes 0,7V to turn on.
Fig. 10-5: Crossover distortion
Application: High power stages, not used in audio applications.
Solution to the crossover distortion:
Provide some forward bias for the base emitter junction.
Fig. 10-6: Class AB amplifier
Fig. 10-7: Complementary push pull amplifier
Two complementary transistors are used (NPN + PNP) , so no transformer is needed any more.
Efficiency: between A and B
Application: High power stages in audio and radio-frequency applications.