Cover Image
close this book A training manual in conducting a workshop in the design, construction, operation, maintenance and repair of hydrams
View the document Contents
View the document Foreword
View the document Introduction
Open this folder and view contents Guidelines for users
Open this folder and view contents Session 1: Introduction to training (1½ hours)
Open this folder and view contents Session 2: Introduction to hydrams (3½ hours)
Open this folder and view contents Session 3: Water measurement techniques (3 hours)
Open this folder and view contents Session 4: Measuring heads and distance (2-4 hours)
Open this folder and view contents Session 5: Review exercise #1 (2 hours)
Open this folder and view contents Session 6: Hydram theory (2-3 hour)
Open this folder and view contents Session 7: Basic plumbing tools and materials (1-1½ hours)
Open this folder and view contents Session 8: Hydram construction - Pipefitting (4 - 6 hours)
Open this folder and view contents Session 9: Hydram design theory and parameters (2 hours)
Open this folder and view contents Session 10: Hydram construction - concrete (18 hours over a 7 day period)
Open this folder and view contents Session 11: Hydram component design criteria (1-1½ hours)
Open this folder and view contents Session 12: Hydram selection (1½ - 3 hours)
Open this folder and view contents Session 13: Inter-relationships within the hydram (11-15 hours)
Open this folder and view contents Session 14: Repair and maintenance (2-4 hours)
Open this folder and view contents Session 15: Review exercise #2 (2 hours)
Open this folder and view contents Session 16: Use of multiple rams (1½ hours)
Open this folder and view contents Session 17: Site development (2 hours)
Open this folder and view contents Session 18: Hydram system site selection (2-4 hours)
View the document Session 19: Project planning (2-4 hours)
View the document Session 20: Wrap up and evaluation (2-4 hours)
View the document Glossary of terms
View the document English-metric units conversion table
View the document References
Open this folder and view contents Attachments

Session 20: Wrap up and evaluation (2-4 hours)

Time: 2-4 Hours

OBJECTIVES:

evaluate workshop activities

· provide closure to workshop

OVERVIEW: This session will vary with the actual situation. At a minimum, evaluation forms should be completed, and workshop sponsors should have the opportunity to "close the workshop' with a restatement of their intent the development and use of this technology and the skills of the participants.

TRAINER PREPARATION: The disposition of constructed rams is an issue that has probably come up by now. This is a good time to give them away, or announce the decisions. Suggestion: ask interested parties to submit proposals for the rams.

Determine whether or not certificates will be given, and make sure they're printed and ready.

Develop an evaluation form. A sample is attached.

MATERIALS: Depending on above decisions.

Evaluation form, pens, pencils,

Participant roster it one has not yet been distributed.

PROCEDURES

NOTES

1. State the purpose of the activity. Ask participants if they have any loose ends that need to be tied up. If so, list these on a flipchart developing an agenda of sorts.

 

2. Distribute evaluation forms. Allow about 20-30 minutes to complete.

 

3. Ask workshop sponsor to close, perhaps with certificates, it appropriate.