Cover Image
close this book Wells construction: hand dug and hand drilled
View the document Acknowledgments
View the document Introduction
close this folder Section one: Planning
close this folder Chapter 1: Introduction to wells planning
View the document A. Overview
View the document B. The need for adequate water supply
View the document C. Involving the local community
View the document D. Selecting the most appropriate water source
View the document E. Site choice
View the document F. Preventing water contamination
View the document G. Types of wells
View the document H. Well sections
View the document I. Materials
View the document J. Tools and equipment
View the document K. Sinking method
View the document L. Preparation for construction
View the document M. Planning
close this folder Section two: Hand dug wells
View the document Chapter 2: Introduction to hand-dug wells
View the document Chapter 3: Well design
View the document Chapter 4: Supplies
View the document Chapter 5: Lowering and raising workers and equipment
View the document Chapter 6: Digging
View the document Chapter 7: The middle section: overview of lining techniques
View the document Chapter 8: Construction of the middle section
View the document Chapter 9: Construction of the bottom section
close this folder Section three: Drilled wells
View the document Chapter 10: Introduction to drilled wells
View the document Chapter 11: Drilling and casing techniques
View the document Chapter 12: Construction: hand rotary and hand percussion methods
View the document Chapter 13: Construction: sludger method
View the document Chapter 14: Construction: driven and jetted
View the document Chapter 15: The bottom section
close this folder Appendices
View the document Appendix I: Conversion factors and tables
View the document Appendix II: Vegetation as an index of ground water
View the document Appendix III: Uses of dynamite in hand dug wells
View the document Appendix IV: Cement
View the document Appendix V: Leveling and plumbing the mold
View the document Appendix VI: Pipe
View the document Appendix VII: Pumps
View the document Appendix VIII: Water treatment in wells
View the document Appendix IX: Rope strength
View the document Glossary
View the document Annotated bibliography

A. Overview

There is water at some depth almost everywhere beneath the earth's surface. A well is a dug or drilled hole that extends deep enough into the ground to reach water. Wells are usually circular and walled with stone, concrete or pipe to prevent the hole from caving in. They are sunk by digging or drilling through one or more layers of soil and rock to reach a layer that is at least partially full of water called an aquifer. The top of the aquifer, or the level beneath which the ground is saturated with water, is called the water table. In same areas there is more than one aquifer beneath the water table. Deep wells, such as those sunk by large motorized equipment, can reach and pull water from more than one aquifer at the same time. However, this manual will only discuss sinking wells to the first usable aquifer with hand-powered equipment.