Sawing - Course: Manual woodworking techniques. Instruction examples for practical vocational training (Institut für Berufliche Entwicklung, 23 p.): Instruction Example 2.2. Cutting to Length of Strips (Frame Strips)

Sawing - Course: Manual woodworking techniques. Instruction examples for practical vocational training (Institut für Berufliche Entwicklung, 23 p.)

(introduction...)

Preliminary Remarks

Instruction Example 2.1. Cutting to Length of a Board

Instruction Example 2.2. Cutting to Length of Strips (Frame Strips)

Instruction Example 2.3. Overlapping Joint

Instruction Example 2.4. Cutting of Plies

Instruction Example 2.5. Curves

Strips shall be manufactured from the board cut to length acc. to instruction example 2.1.

Figure

Material

A board cut to length as per instruction example 2.1.

Tools, measuring and testing means

Folding rule, pencil, try square, straightedge, frame saw (ripping saw), pad saw, cutting angle = 90°

Auxiliary accessories

Saw horses, carpenter’s bench

Necessary previous knowledge

Measuring, scribing, reading of drawings

Sequence of operations		Comments

1.	Prepare the working place.	Check for completeness.

2.	Place the material on the bench.

3.	Scribe the side line on the natural bevel and the width lines of the strips.	Consider the width allowance and the cuts.

4.	Clamp the workpiece in such a way that the cutting line runs parallel to the bench’s edge.	When cutting to length with the grain push-type cutting teeth are required; check the sharpness of the saw.

5.	Select and check the saw.

6.	Cut off the natural bevel (edging).

7.	Clamp the workpiece again.

8.	Cut off the strips.	Repeat until the required number of strips is produced.

9.	Check the result.	The produced strips are used for the instruction example 2.3.

Figure